eMMC Pro: Universal ISP and SDIO Solutions for Mobile Phone Repair

Description

 eMMC PRO

eMMC Pro is a universal programmer that supports ISP/ICP connection BGA162/186/153/169/221 with eMMC connector F.

Introduction :
eMMC Pro is a universal ISP and SDIO solution for repairing mobile phones. It supports ISP connections for repairing mobile phones and has a support page that contains an archive of repair files for mobile phones.

eMMC PRO

Hardware Features

Summary : Advanced hardware features for efficient and reliable mobile phone repair.

In-System Programming (ISP)

It is the ability of devices to be programmed while installed in a complete system, rather than requiring the chip to be programmed prior to installing or prior to being mounted. ISP operations enable users to directly recover the complete data without removing the chip (eMMC, eMCP, NAND, etc.).

Integrated Voltage Control

All (I/O) levels will be detected automatically for the eMMC / Device Levels.

eMMC Pinout / Connections

D0 / DAT0 / DATA0, CMD, CLK, VCC, VCCQ, GND
The more D/DAT/DATA pin connected, the faster it will be. Most eMMC devices are 8bit(s) (D0,D1,D2,D3,D4,D5,D6,D7).

Support Page

Free unlimited technical documents, pinouts, manuals, and mobile phone dumps, files resources.

Low-Level Access

eMMC Pro HW and SW is able to access the eMMC every part / partitions and zones, so you won't miss a spot! eMMC Pro is designed for low-level operations and designed for professionals (not just a simple reader).

eMMC PRO Software Features

Summary : Advanced software features for efficient and reliable mobile phone repair.

Direct Partition Access

Accessing the necessary partitions saves time and lets you accomplish the job in a short time.

Stop / Resume | Fail / Resume

There are many reasons you want to stop on-going reading or you want to continue later. A resume is such an option that lets you complete the previous operations in the future.

Supported Devices

Summary : eMMC Pro supports a wide range of devices.

Package Contains

• 1 x eMMC Pro Box
• 1 x eMMC Booster Box
• 1 x BGA 153 PCB Break-out board
• 1 x BGA 162 / 221 PCB Break-out board
• 1 x Soldering Cables
• 1 x Thin Soldering cable roll
• 3 x 20 pin Cables

 NOTE: We don't guide you on how to use it. Make sure you know how to use it before buying it. However, you can still find solutions or help from the official site or at https://www.martview-forum.com/