ISOFT IS-004 HW Chrysanthemum 3rd Gen: 1.0 Port USB Artifact with Card Brush Head

iSOFT IS-004 HW Chrysanthemum 3rd Gen USB 1.0 Port Artifact with Card Brush Head

Product Introduction
This tool solves the issue of new batch chrysanthemum and Hongmeng system devices not connecting to USB 1.0 port under normal short-circuit conditions. It requires disassembling the device and performing a series of operations, similar to before.

Product Use
This product helps to:

• Solve the problem of USB 1.0 not appearing after disassembling and short-circuiting the new version.
• Support bottom-level programming with related software and mobile phone operations.
• Supported models: Chrysanthemum Kirin series (including Hongmeng).
• Summary:** Forces USB 1.0 port to start engineering mode, allowing connection to computer and normal operation.

Button Description
The transfer switch is the button to start and close the engineering mode:

• In the off state, the adapter can be used as a normal line by plugging in the data cable to connect to the mobile phone.
• In the startup state, enter the engineering mode, you can force the USB 1.0 port to start the engineering mode, plug the adapter into the computer separately, and the computer will prompt that the USB device cannot be recognized.
• When the mobile phone is connected, there will be no such prompt, and it can be connected normally.

Instructions for Use
Follow these steps:

• Short-circuit the mobile phone (the same steps as before).
• Start the adapter to the engineering mode and insert it into the mobile phone (the steps are the same as before but with an extra adapter).
• The computer will have a long-lost USB 1.0 port, then burn the bottom layer through your software (that is, turn on BL).
• After writing the bottom layer and switching to fast boot mode, press the switch twice (you can test it by yourself at an interval of 3 seconds).
• The computer will come out ADB driver, hi yourself later.

Package Includes
This package includes:

• 1 x Tester
• 1 x Card Brush Head

Notes
Please note:

• It is only to assist in entering the 1.0 mode, and it still needs to be short-circuited.
• At present, it cannot be directly unlocked, just the adapter, and then connect to ordinary data cable products through this header.
• This product is only suitable for senior maintenance personnel.