SuperPro 6100N Universal Programmer and Burner

SuperPro 6100N Universal Chip Programmer

The SuperPro 6100N is a USB interface ultra-fast universal programmer designed for MCU, CPLD, FPGA, and EEPROM devices. It's ideal for programming houses, electronic circuit board repair, Car ECU repair shops, forensic and data recovery companies, and medical devices that require larger device support.

Key Features

The SuperPro 6100N is a cost-effective, reliable, and high-speed universal chip programmer that offers:

• Ultra-Fast Programming Speed: Up to 4 times faster than other programmers in the industry, thanks to our semiconductor manufacturer approved algorithms and state machine architecture constructed with FPGA.
• Largest Device Support Count: With 144 pin drivers, it can support high pin count chips, eliminating the need for special adapters and bottom boards.
• Stand-Alone Mode: Operate without a PC, ideal for production environments, and reduce labor and PC costs.
• Built-in Tester for Logic Devices and SRAMs: Test TTL, CMOS Logic (74/4000 series), and SRAM memory devices in addition to programming.

Devices and Package Types Supported

The SuperPro 6100N supports a wide range of devices and package types, including:

• Devices: EPROM, Paged EPROM, Parallel and Serial EEPROM, FPGA Configuration PROM, FLASH memory (NOR), BPROM, NVRAM, SPLD, CPLD, EPLD, Firmware HUB, Microcontroller, MCU
• Package types: DIP, SDIP, PLCC, JLCC, PGA, LGA, SOIC, SOJ, SOT, QFP, TQFP, PQFP, VQFP, MQFP, LQFP, TSOP, SOP, TSOPII, PSOP, SSOP, TSSOP, SON, EBGA, FBGA, FTBGA, VFBGA, μBGA, CSP, SCSP, QFN, HVQFN, etc.

Technical Specifications

• PC interface: USB 2.0
• Stand-alone memory
• Compact FLASH Card
• AC Adapter: Input AC 100V- 240V; Output: 12V/1.5A
• Dimensions: Main unit: 148(L) x 216(W) x 94(H) mm, Package: 301(L) x 252(W) x 145(H) mm

Expanded Features

• Concurrent Multi-Programming System: Operate multiple units to construct a concurrent multi-programming system, ideal for flexible volume production.
• Support devices with Vcc from 1.2V - 5V.
• Support files up to 256 GB.
• Over-current and over-voltage protection for safety of the chip and programmer hardware.
• Only IC manufacturer approved programming algorithms used for high reliability.
• Vcc verification (at +5% ~ -5% and +10% ~ -10%) enhances programming reliability.